Product Showcase
-
Die On Carrier, Silicon Digital Attenuator: ADRF5474
6/17/2022
The ADRF5474 is a 4-bit digital attenuator with 22 dB attenuation control range in 2 dB steps manufactured in a silicon process attached on a gallium arsenide (GaAs) carrier substrate. The substrate incorporates the bond pads for chip and wire assembly, and the bottom of the device is metalized and connected to ground.
-
GaN Power Amplifier Module: QPA3908
5/20/2022
The QPA3908 is an integrated 2-stage Power Amplifier Module designed for massive MIMO applications with 8 W RMS at the device output covering frequency range from 3.7 to 3.98 GHz.
-
S1G6C Series Amplifiers
5/6/2022
S1G6C models are Class A, solid-state, self-contained, air-cooled, broadband amplifiers designed for applications where instantaneous bandwidth, high gain, and linearity are required. They protect against input overdrive beyond 0 dBm and various failure conditions, including over-temperature and power supply faults.
-
Holzworth Real Time Phase Noise Analyzers: HA7062 Series
5/4/2022
The HA7062 Series Real Time Phase Noise Analyzers have been optimized with both analog and digital hardware techniques. These fully integrated phase noise analysis systems utilize real time, dual core engines for cross correlation speed, which are coupled with a pair high performance internal LOs (RF Synthesizers) from Holzworth's HSX Series RF Synthesizers.
-
Holzworth Broadband PLL-Based Frequency Sources: HSX Series
5/4/2022
The HSX Series are broadband PLL based frequency sources that offer excellent noise and spectral purity performance coupled with a highly accurate dynamic range of up to +20dBm and down to -110dBm. The 1U high form factor offers 1, 2, 3 or 4 channel models; all providing solid frequency accuracy with phase coherent RF outputs for high end channel-to-channel stability.
-
Noisecom Calibrated Coaxial AWGN Noise Source: NC3000 Series
5/4/2022
Noisecom's NC 3000 Series calibrated coaxial AWGN noise sources are well suited for receiver testing, noise figure measurements, or applications that require broadband noise and fast switching times.
-
Non-Blocking Matrix Switch: 50MS-426
4/14/2022
JFW's 50MS-426 is a 50 Ohm non-blocking matrix switch operating 350-6000MHz. The switch can be remotely controlled via Ethernet or RS-232 connection, and the IP settings can be manually set via the front panel display.
-
GaN On SiC RF Transistor: QPD1028
4/13/2022
The QPD1028 is a 750W discrete GaN on SiC HEMT that operates from 1.2 to 1.4 GHz, providing typically 59dBm of saturated output power with 18dB of large-signal gain and 70% of drain efficiency.
-
L1/L2 Low Loss GPS SAW Diplexer: QPQ1063
4/13/2022
The QPQ1063 is a L1/L2 GPS diplexer in a compact size for use in any GPS application. Designed for rejection of unwanted GPS signals, this SAW diplexer also has excellent power handling capability for low power transmitters.
-
Ray-Tracing With Physical Optics And MEC
3/9/2022
Physical Optics (PO) is a ray-based physics technique that is very effective for radar scattering and other applications that require calculation of backscatter from detailed faceted objects.