13 Watts CW, 0.8 to 4.2 GHz Microwave Power AmplifierSource: AR
The 10S1G4A microwave power amplifier, when used with a sweep generator, will provide a minimum of 10 watts of RF power. Included is a front panel gain control which permits the operator to conveniently set the desired output level. The 10S1G4A is protected from RF input overdrive by an RF input leveling circuit which controls the RF input level to the RF amplifier first stage when the RF input level is increased above 0 dBm. The RF amplifier stages are protected from over temperature by removing the DC voltage to them if an over temperature condition occurs due to cooling blockage or fan failure.
There is a digital display on the front panel to indicate the operate status and fault conditions when an overtemperature or power supply fault has occured. The unit can be returned to operate when the condition has been cleared. The 10S1G4A includes digital control for both local and remote control of the amplifier. This 8-bit RISC microprocessor controlled board provides both IEEE-488 (GPIB) and asynchronous, full duplex RS-232 control of all amplifier functions.